Tools & Supplies
Uniforms
Uniforms are not required but each student must have safety glasses and leather work shoes. Sneakers and shorts are not allowed in laboratory areas.
Tools
Students are responsible for having their own tools. The minimum tools needed for completion of this program are listed below.
|
1/4" drive socket set | |
|
3/8" drive socket set | |
|
1/2" drive socket set | |
| Combination Wrench Sets - 5/16, 11/32, 1/4, 3/8, 7/16, 1/2, 9/16, 5/8, - Metric - combination 7-19 MM | |
| Tire inflater | Line wrenches 8mm - 17mm |
| 1 Torque Wrench 3/8" drive, 30 to 200 inch lbs | 1 Fender cover |
| 1 Pocket screw driver | Pocket telescoping magnet |
| Screwdriver set 3 phillips, 4 standard |
Electrical wire pliers |
| Scratch awl (ice pick) | Safety glasses |
| Air Nozzle with rubber tip | Leather shoes |
| Tire pressure gauge 15-60 lbs. |
1 tool box (minimum 3 drawer rolling type cabinet) |
| Files: 12" round, 12"flat | Dial Indicator - measure in .001" increments clamp-on-base |
| Micrometer torque wrench, 1/2" drive with ratchet (10 to 150 ft. lb. range) |
1 pr. needle nose pliers, with cutter to 6" length |
| 1 pr. interlocking pliers 8" to 9" length | 1 pr. vice grip pliers 7" length (approx.) |
| 1 pr. slip point pliers approx. 6" length | 12 volt electric test light |
| 1 gasket scraper (putty knife) | heavy duty diagonal side cutter 6" length |
| true-arc internal & external (conventional) | inspection mirror |
| 2 ball peen hammers | 1 punch set - 5 piece - 1/8, 5/16, 3/8, 7/16, 1/2 |
| spark plug guage set (wire type) .035 to .080 | feeler guage - flat type ignition and valuve 45" |
| 1 batter post cleaner | 1 cold chisel set - 5 piece - 5/16, 7/16, 1/2, 5/8, 11/16 |
| 1 thermometer pocket type | snap ring pliers |
| magnetic tool with handle | 14 piece metric hex wrench set 2mm - 19mm |
| torx screwdriver set T15-T30 | leather gloves for welding, goggles #5 lens & tip |
| angled pick | 1 - 6" electronic digital readout caliper metric/inch conversion |
| wire brush | Pocket ruler 6" both metric & inches |
| Hand-held digital multimeter Minimum Required Features: - D.C. volts, 0.5 percent accuracy or better - A.C. volts - D.C. current, 0-10 amps or 0-20 amps - Resistance, Diode Check - Frequency, 0-50Khz - Duty cycle Optional features: - Temperature - RPM - Dwell - Max-min-average - Data hold - Analog bar graph - Pulse Width (MS) | |
© EICCD | 306 West River Drive Davenport, IA 52801 | For Information call: 1-800-462-3255
eiccinfo@eicc.edu